C3640-jk9s-mz.124-16.bin Ios 50

C3640-jk9s-mz.124-16.bin Ios 50

Click Here ---> https://cinurl.com/2tyANK

How to Use c3640-jk9s-mz.124-16.bin IOS Image on GNS3

If you are preparing for Cisco exams, you may want to use GNS3 to emulate Cisco routers and switches. GNS3 is a network simulator that allows you to create complex network topologies and test your configuration skills. However, to use GNS3, you need to download and add Cisco IOS images to the program.

One of the IOS images that you can use on GNS3 is c3640-jk9s-mz.124-16.bin. This image is suitable for Cisco 3600 series routers, such as c3640, c3660, c3725, and c3745. It supports many features that you may need for your exam preparation, such as routing protocols, switching, security, voice, and more.

In this article, we will show you how to use c3640-jk9s-mz.124-16.bin IOS image on GNS3. We will assume that you have already installed GNS3 on your computer and that you have downloaded the IOS image from a reliable source. If you need help with these steps, you can check out this article[^1^] or this video[^2^].

Step 1: Add the IOS Image to GNS3

The first step is to add the IOS image to GNS3. To do this, follow these steps:

Open GNS3 and go to Edit > Preferences.

Select Dynamips > IOS Routers from the left pane.

Click on New to create a new router template.

Select New Image and browse to the location where you saved the c3640-jk9s-mz.124-16.bin file.

Click on Open and then Next.

Select the platform as c3600 and the model as c3640.

Click on Next and then Finish.

You should see the new router template in the list of available routers. You can rename it if you want.

Step 2: Configure the Router Settings

The next step is to configure the router settings, such as RAM, IDLE-PC, slots, etc. To do this, follow these steps:

Select the router template that you created in the previous step and click on Edit.

Go to Memory tab and set the RAM value to 128 MB. This is the minimum RAM requirement for this IOS image.

Go to Advanced Settings tab and click on Idle-PC finder. Wait for a few seconds until GNS3 calculates a suitable Idle-PC value for your computer. Select one of the suggested values and click on Apply.

Go to Slots tab and add modules to the router slots as per your needs. For example, you can add NM-16ESW module to enable switching capabilities on the router.

Click on OK to save the changes.

You have now configured the router settings for using c3640-jk9s-mz.124-16.bin IOS image on GNS3.

Step 3: Drag and Drop the Router to the Workspace

The final step is to drag and drop the router to the workspace and start using it. To do this, follow these steps:

Go to Routers section in the left pane and drag and drop the router template that you created to the workspace.

Right-click on the router and select Start to power it on.

Right-click on the router again and select Console to open a terminal window.

You should see the router booting up with the c3640-jk9s-mz.124-16.bin IOS image.

You can now configure the router as per your needs.

Congratulations! You have successfully used c3640-jk9s-mz.124-16.bin IOS image on GNS3. 061ffe29dd